This is the most powerful Speed controller in the whole Kelly product catalog for Brushed DC Motors. This controller is better and more powerful than the venerable Curtis Controller and other expensive brands. I have tested the new generation of Kelly Controllers for the last 7 years in several EV Conversions: VW Bugs and Buses, Porsche Speedsters, MINI Coopers, Peugeots, Nissan Trucks, Renaults, etc. Kelly offers good performance controllers at an affordable price.This is a very good controller for all DC Series Brushed Motors. NetGain TansWarp7, ImPulse9, Warp9, Warp11 and Warp13. Kostov DC Series K9, K10, K11, K13, Dual Motors. Advanced DC Motors, now AMD Motors FB-4001 9" and 8" Motors. Mars Electric Motenergy ME1002 10 DC Series Motor.
Vintage General Electric Motors 9", 11" and other Fork Lift DC Series Motors. Permanent Magnet Motors (any brand), in this case YOU GET REGENERATIVE BREAKING with this controller. This controller with any 9 motor or bigger can move easily 3 Tons, TESTED in toll roads. This product Includes J1 and J2 harnesses, USB-Serial cable, Software, User's Manual and 1 hour support for free , I can provide a video of this controller moving the Motor or the truck.Amperage ratings are measured from the MOTOR SIDE, not from Battery side as this controller does current multiplication. I can pre-program the controller for your specific needs like: throttle type, battery under voltage to protect your cells from over-discharging. USE ONLY 4/0 awg cables FROM the controller TO the Motor, otherwise your cables will heat beyond 700A. You can use 2/0 awg cables from your battery pack to the controller. Configurable battery voltage range: 20V to 136V. Motor Current Limit, 1 minutes: 1500A. Motor Current Limit, continuous: 750A. Motor speed controller uses high power MOSFET, fast PWM to achieve efficiency 99% in most cases. Powerful microprocessor brings in comprehensive and precise control to brushed motor controllers. Synchronous rectification, ultra low drop, and fast PWM to achieve very high efficiency. Current limit and torque control. Voltage monitoring on voltage source 12V and 5V. Support torque mode, speed mode, and balanced mode operation. Configurable limit for motor current. Battery protection: current cutback, warning and shutdown at configurable high and low battery voltage. Rugged aluminum housing for maximum heat dissipation and harsh environment. Rugged high current terminals, and rugged aviation connectors for small signal. Thermal protection: current cut back, warning and shutdown on high temperature. Configurable high pedal protection: the controller will not work if high throttle is detected at power on. Brake switch is used to start regen.
0-5V brake signal is used to command regen current. Easy installation: 1-4V Hall Active throttle or 3 Wire potentiometer. Standard PC/Laptop computer to do programming.Frequency of Operation: 16.6kHz. Controller supply voltage range, PWR, 10 to 30V(24V is preferred). Standard Throttle Input: 0-5 Volts(3-wire resistive pot), 1-4 Volts(hall active throttle). Analog Brake and Throttle Input: 0-5 Volts.
Producing 0-5V signal with 3-wire pot. Reverse Alarm, Main Contactor Coil Driver, Meter. Full Power Temperature Range: 0 to 50 (controller case temperature).Operating Temperature Range: -30 to 90, 100 shutdown (controller case temperature). The item "Racing Speed Controller for DC Series and Permanent Magnet Motors, 120V 1500A" is in sale since Sunday, November 24, 2019. This item is in the category "eBay Motors\Parts & Accessories\Performance & Racing Parts\Other". The seller is "eds_pda" and is located in Mexico City. This item can be shipped worldwide.